![]() ![]() If we have Desktop computer then we should use the Wi-Fi adopters. In this detailed post we learn how we can install Wi-Fi in Kali Linux. Let me know if that helps, or if you need further assistance once you've gotten to the point of finding APs and clients and want to continue on towards hacking WEP or WPA2 or WPS.Sometimes internal WiFi adapter not found in our Kali Linux system. So I'm not entirely sure what your issue is and the purpose of the rausbX command or display you mentioned, but I would suggest picking up an Alpha card if you don't have one, and using these commands to find APs and clients. This will show you both the broadcast strength of the XX:XX:XX:XX:XX:XX access point, as well as the RXQ, and it will show any clients (STATION) on that WLAN, and their status, whether associated, or not associated and probing for the AP. X = variable obviouslyĪirodump-ng -c X -bssid XX:XX:XX:XX:XX:XX mon0 These will put your wireless interface into monitor mode, and then start monitoring the "air" for traffic from any and all near access points and clients.Īfter you zero in on an AP you wish to monitor, (CTRL+C to stop monitor) you should focus on its channel and BSSID so you can see the RXQ (receive quality) so you can see if there is a lot of interference in the signal. After looking at thisĭoes it just display your interface as rausb0 rather than wlan0? As far as finding access points and connected clients, I use and recommend these standard commands. ![]() Regarding the rausb0 command, I'm not familiar with it. The Alpha cards have built in driver support in Kali, and they're very reliable, so I'd recommend one of them. It may have inadequate driver support, but it may also be that you're too far away from the access point (AP), and the broadcast power (PWR) isn't strong enough (higher numbe is better, lower is worse ), or you have poor receive quality (RXQ - higher number is better, lower is worse), meaning there is interference. Well it might be coming down to what adapter you're using. It's not a big deal to me though because I'm currently not working on WLAN hacking, and I do all my hacking in VMs on my desktop.įinally, here is a very good video series on WLAN hacking. I haven't figured out away to fully encrypt the disk with a dual booting configuration, so for the time being I'm not dual booting. I'd like to dual boot it on my laptop, but my problem with that is I use Linux Mint as my main OS and use my laptop for school, and I do full disk encryption. My preferred setup is installing Kali to the hard drive. Here's a video I came across after a quick search though which may provide a solution to the USB interface problem within the VM, but I haven't gone through it yet to see if it solved my problem. You may also run into issues with the Kali VM recognizing your USB wifi adapter, like I have, so you may be better off burning to a DVD and live booting, or even installing Kali in a dual boot configuration. A popular choice for WLAN hacking is the Alpha AWUS036NH. ![]() What USB wifi adapter are you using? You'll have zero luck if it's also one that doesn't support packet injection. You can't use the laptop's card because it almost certainly doesn't support packet injection. First of all, I assume you're referring to the aircrack suite of tools, not just the aircrack-ng handshake cracking tool, correct? ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |